[SOLVED] Link colors on the wrong side

[Rahvin_]

My weathermap install draws the collors on the wrong side of the link as you can see in the following image. The bandwidth numbers on the link are correct, there is 25 mbit outgoing and 12 incoming. The purple arrow should point the other way and so should the blue one. Swapping them around by changing the order of the NODES or by changing the DS order in TARGET swaps both the label and the arrows, so its still the wrong order.

[Howie]

Could you paste the whole config for that link please? (and the DEFAULT link)

My guess at the moment is that since you changed the position of the labels, it's not hard to get the in/out the wrong way around in the BWLABELPOS line.

It would normally be a high number then a low number: BWLABELPOS 75 25 is the default, for example.

[Rahvin_]

[gkhnyldrm]

My weathermap links shows the colours on the wrong side and cacti images are wrong too,download and upload lines are inverted. Because of this wrong images I think weathermap retrieves wrong data from cacti and creates wrong links. To correct both upload and download traffic I changed inbound data source to -> (traffic_out) and outbound data source to -> (traffic_in) then cacti graphs recovered but links are still wrong. Then I undo my changes,Here is my weathermap image http://193.255.52.200/

For example 'mühendislik' has 250% outbound traffic and 20% inbound traffic,but it must be 250% download and 20%upload.

[Howie]

[gkhnyldrm]

my weathermap config is below;

[Howie]

[gkhnyldrm]

OK it's SOLVED!

I have changed the link's configuration;

[Howie]

Then maybe you have misunderstood something...

In a Link, where you have NODES A B, the target should always refer to an interface on node A. So 'in' means 'in to node A' and 'out' means 'out of node A'.

If you do *both* the things you said (swap the nodes, and swap the in/out in cacti), then you end up back where you started!

[gkhnyldrm]