Cacti graphs cannot display

Post general support questions here that do not specifically fall into the Linux or Windows categories.

Moderators: Moderators, Developers

Post Reply
Author
Message
wchung
Posts: 1
Joined: Thu Oct 31, 2019 5:35 am

Cacti graphs cannot display

#1 Post by wchung » Thu Oct 31, 2019 5:40 am

We tried to use OID to create cacti graphs for a Dell FX2 poweredge switch.
We were able to retrieve the data from snmpwalk as shown below.
However, the cacti graph did not show anything, refer to the attached screen capture.
Is there any ideas?

[07:45:37 [email protected]:~]
# snmpwalk -v2c -c noc_snmp 172.17.0.25 1.3.6.1.4.1.6027.3.26.1.4.4.1.1
SNMPv2-SMI::enterprises.6027.3.26.1.4.4.1.1.2.1.1 = Gauge32: 8
[07:46:47 [email protected]:~]
# snmpwalk -v2c -c noc_snmp 172.17.0.25 1.3.6.1.4.1.6027.3.26.1.4.4.1.5
SNMPv2-SMI::enterprises.6027.3.26.1.4.4.1.5.2.1.1 = Gauge32: 7
Attachments
cacti_graphs.png
cacti_graphs.png (68.68 KiB) Viewed 140 times

Post Reply