We tried to use OID to create cacti graphs for a Dell FX2 poweredge switch.
We were able to retrieve the data from snmpwalk as shown below.
However, the cacti graph did not show anything, refer to the attached screen capture.
Is there any ideas?
[07:45:37 [email protected]:~]
# snmpwalk -v2c -c noc_snmp 172.17.0.25 126.96.36.199.4.1.6027.3.26.1.188.8.131.52
SNMPv2-SMI::enterprises.6027.3.26.1.184.108.40.206.2.1.1 = Gauge32: 8
[07:46:47 [email protected]:~]
# snmpwalk -v2c -c noc_snmp 172.17.0.25 220.127.116.11.4.1.6027.3.26.1.18.104.22.168
SNMPv2-SMI::enterprises.6027.3.26.1.22.214.171.124.2.1.1 = Gauge32: 7
Post general support questions here that do not specifically fall into the Linux or Windows categories.
1 post • Page 1 of 1